Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Duet wifi: short-to-ground

    Scheduled Pinned Locked Moved
    Duet Hardware and wiring
    wifi duet short-to-ground short-to-ground standstill sg minmax not available
    2
    2
    386
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Electrique_Vegtechundefined
      Electrique_Vegtech
      last edited by

      Hi,

      I just purchased a duet wifi from an authorized reseller and I started by following your tutorial to get the software up and running while updating it to 3.1.1. I checked the controller state and I get the following error for both X and Y axis drivers:

      short-to-ground standstill, SG min/max not available

      Only thing plugged in is the +24v. I'm a bit cautious to go any further since I read online this is probably caused by bad drivers.

      Thanks,
      Daniel

      1 Reply Last reply Reply Quote 0
      • Phaedruxundefined
        Phaedrux Moderator
        last edited by

        Can you post the results of M122 and M98 P"config.g"?

        Please verify that your motor phases are wired correctly.

        https://duet3d.dozuki.com/Wiki/Choosing_and_connecting_stepper_motors#Section_Identifying_the_stepper_motor_phases

        Once you have the phases correctly identified if you're still getting the error message they the motor on a different driver to see if the error follows the motors. similarly, try a motor that worked on another driver and try it on the X/Y to see if the error is still present. This will help us determine if it's a driver problem.

        Z-Bot CoreXY Build | Thingiverse Profile

        1 Reply Last reply Reply Quote 0
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA