Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    [3.2-RC1] Hotend heater fault with fan on

    Scheduled Pinned Locked Moved Solved
    Beta Firmware
    3
    3
    171
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • SAtechundefined
      SAtech
      last edited by

      Not sure if this is already known, but I think I have encountered a bug. On the first couple layers of a small object, the temperature setpoint changes, and the fan turns on to 100%, according to my slicer settings. However, the hotend struggles to keep up, and faults with "temperature rising too slowly". I do have a pretty powerful fan, but I'm also using a block sock. This is with a v6 hotend. I did tune with the new algorithm using M303 T0 S245, which did activate the fan.

      1 Reply Last reply Reply Quote 0
      • PCRundefined
        PCR
        last edited by

        Have you saved the PID tune via M500? Can you Post the confit override.g? There was a small Bug where a space was missing

        1 Reply Last reply Reply Quote 0
        • Phaedruxundefined
          Phaedrux Moderator
          last edited by

          Trying to increase the temp while also turning on the cooling fan is a pretty good way to trip the protection.

          If possible, stagger the fan coming on until after the temp change.

          Z-Bot CoreXY Build | Thingiverse Profile

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA