Did I fry my new board....

[A Former User]

@Harvdog1 said in Did I fry my new board....:

The E gets an error and wants a tool assigned I think.

extruders usually refuse to move when cold. if there is no filament in you can enable it to move when cold with M302 P1 (this is similar to M564 in that it it doesn't do anything on its own and needs to be run again if you reset the board)

https://duet3d.dozuki.com/Wiki/Gcode#Section_M302_Allow_cold_extrudes

or just turn on the heater to at least 160C.