Partcooling Fan doesn't work anymore, Layertime Issue
I noticed that the Partcoolingfan doesn't come on with the M106 command.
in 3.1.1 the Function was no Problem, since 3.2 beta 4.1 and newer (also 3.2)
i have this Issue
on Start of Layer 2 theres 1 line in the Part gcode:
M106 S153 (Fan at about 55%)
i don't know where the issue comes from after the Firmwarechange....
Manually set the Fan over DWC does work, but no M106 command does work...
the other thing is that when i Add an X200 to the Extruderfan M106 the fan doesn't
slow down....but it doesn't move with this max RPM command.
i also noticed that Layertimes are always exactly the same as long as i don't use the DWC....
(the ~150 Points are Exactly 2min and 3seconds when i have closed the Browser, and the last 3-4 points are when i opened DWC in the Browser.
I dont think that is valid
which fans do you actually want to map?
Fan 1 as the Extruderfan for Tool0 and Tool1
Starting at 70degree
Fan 2 as the Partcoolingfan for Tool0 and Tool1
It has worked with that code in 3.1.1
-1 is not a valid fan
fan 1 is temperature controlled and can not be assigned as a tool fan
try just F2
I‘ll try to remove that -1 i don’t remember why it‘s there...
@Veti Thanks, that was the Problem!
because of the Other things,
is it possible to Reduce the Speed/Voltage of the non PWM (24V) Fan over
the Software config.g File? (the Jumper is set to VIN)
X Parameter doesn' Work (FAN1)
some fans do not like to be pwm controlled an run at full speed or none
to change the speed you need to set the S parameter
speed is bettween 0 and 1 so try 0.5 or something.
if that does not work try adjusting the frequency
try default Q500, Q50 or Q25000