Sync 3 independent z axis stepper motors.
stuart.simpson last edited by stuart.simpson
I am trying to find out how to configure a coreXY 3D printer with three stepper motors each using a different driver. so:
X-Axis on driver_0
Y-Axis on driver_1
Z-Axis Stepper 1 on drive_2
Z-Axis Stepper 2 on drive_3
Z-Axis Stepper 3 on drive_4
Duet 3 Mainboard 6HC Revision v1.01
Raspberry Pi 4 4GB
I assume that there is an article out here that talks about doing it but I have been unsuccessful at finding it. I am happy to do the reading but could someone point me in the right direction.
I am hoping this can be done in the RepRapFirmware Configuration Tool (may be a bad hope )
Thanks for the help.
Veti last edited by
it can not be done in the configuration tool
stuart.simpson last edited by
Thank you for pointing me in the right direction.