Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Probe header

    Scheduled Pinned Locked Moved
    Duet Hardware and wiring
    3
    3
    875
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • RCarlyleundefined
      RCarlyle
      last edited by

      What are the four probe header pins for? I'm using David's dIR probe. Do I use Z_PROBE_IN or Z_PROBE_MOD for the signal line?

      1 Reply Last reply Reply Quote 0
      • Dougal1957undefined
        Dougal1957
        last edited by

        Z_PROBE_IN the _MOD is for the modulated type that where supplied by RepRapPro on the Ormerod and is supplied for Compatability with those probes.

        I set mine up finally yesterday and hope to do some serious testing later today once I get work finished

        Doug

        1 Reply Last reply Reply Quote 0
        • dc42undefined
          dc42 administrators
          last edited by

          Currently the Probe connector is only for sensors that can produce an analog output, such as my IR sensor. As Doug says, ignore the MOD pin. Other sorts of Z probe should use the E0 endstop connector and probe type 4 in the M558 command in config.g.

          I plan to add probe type 5 which would be a probe with a digital output but connected to the Probe connector instead of E0 endstop.

          Duet WiFi hardware designer and firmware engineer
          Please do not ask me for Duet support via PM or email, use the forum
          http://www.escher3d.com, https://miscsolutions.wordpress.com

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA