Hot Melt Glue Gun extruder
-
Hello
I want to attach an inexpensive 110v hot melt glue gun to my printer. The idea is to wait about 5 minutes for the nozzle to reach proper temperature and then hit "go" on the print.
Is there a way to disable or circumvent the heater / thermistor setup on the Duet 085, so that I can use the 110v hot glue gun instead?
(Worth noting: I understand the danger involved with what I'm asking about and accept full responsibility for any outcome. Thank you in advance for any concerns)
-
How about setting the extruder temperature at zero and allowing cold extrusions?
https://duet3d.dozuki.com/Wiki/Gcode#Section_M302_Allow_cold_extrudes
Will that work for you?
-
Sounds good, will try this out. Thank you Alan!
-
-
If you don't include any heaters in your M563 tool configuration command in config.g then cold extrusion will be allowed automatically.
