G32 ignores probe errors?
fcwilt last edited by
I was cleaning up my code and testing auto bed leveling.
Normally when starting G32 the Z co-ordinate is 5.
For one test I issued this before starting to probe: G90 G1 Z50 G92 Z5
The probing began and, as intended, the probe never reached the bed at point 1.
The unexpected part was that the probing continued on to point 2 and point 3.
After all the points were "probed" it did report the probe error.
Does it really make sense to ignore probe errors during the process when any error prevents the process from being successful?