KISS Slicer time estimate not supported in DWC3.2.2

[oliof]

I just noticed that DWC 3.2.2 does not recognize KISSlicers print time markers while DWC 2.0.4 does (I am currently printing the same file on a machine running the newer and another running the older version of DWC).

KISSlicer version is 2 alpha 2.0.6
This is the time estimate information at the end of a gcode file

;
;
;
; Calculated-during-export Build Time: 193.99 minutes
; Estimated-in-GUI Build Time:         194.01 minutes
; Estimated-in-GUI Build Cost:         $0.84
;
; Filament used per extruder:
;    Ext #1  =  8076.61 mm  (19.427 cm^3)
;
; *** Extrusion Time Breakdown ***
; * estimated time in [s]
; * before possibly slowing down for 'cool'
; * not including Z-travel
;
;	| Ext #1  | Path Type
;	========================================
;	| 140.553 | Jump Path                  |
;	| 0       | Pillar Path                |
;	> 0       > Raft Path                  >
;	| 0       | Support Interface Path     |
;	| 0       | Support (may Stack) Path   |
;	| 2786.39 | Perimeter Path             |
;	> 5863.62 > Loop Path                  >
;	| 588.503 | Solid Path                 |
;	| 134.414 | Sparse Infill Path         |
;	| 1443.05 | Stacked Sparse Infill Path |
;	> 65.9231 > Destring/Wipe/Jump Path    >
;	| 201.588 | Crown Path                 |
;	| 12.2082 | Prime Pillar Path          |
;	| 0       | Purge Path                 |
;	> 316.806 > Travel/Ironing Path        >
;	| 0       | Pause Point                |
;	| 86.4    | Extruder Warm-Up           |
;	========================================
; Total estimated (pre-cool) minutes: 193.99

[pkos]

Interesting. Works fine here. Same version of Kisslicer.

I wonder what other differences there are between our machines.
This is from Duet 6HC.
I checked on Duet 3 mini 5+ - also works there for me.