DWC somehow unresponsive while heating

[Phil333]

Hi,

this was a 100% asked before, but I was unable to find it.

When I set the temperature of the extruder via the DWC to lets say 200°C then I have to wait for the temperature to be reached before I can send additional commands.

For example its not possible to set also the bed to 60°C before the extruder is at its desired temp.

Is there a way to make it responsive to other commands while heating up?

Thanks

[jay_s_uk]

@phil333 remove the M116 in the tool change files

[Phil333]

Thank you @jay_s_uk !
removing M116 ifrom
tpost0.g and tpost1.g
solved it

[droftarts]

@phil333 the other thing you can do is activate the tool first with active temperature set to 0, then set the temperature. That way no tool change command is sent, so tool change macros don’t run.

Ian