Beast - P3 Steel XL
Beast .. Updated Prusa P3 Steel XL with a Titan Extruder and an E3D hot end ..
Enclosure for Duet WiFi board is from
with an Artic F8 12V fan for cooling attached with zip ties.
Fan is wired to PSU, so always on..
Whole enclosure is covered when not in use .. a rarity ..
The box for the SSR from:
Beast has a 220V hotbed via an SSR-40DA, overkill, but das ist das ..
Tried imgbb .. How about now?
my67nova last edited by
Cool box. Where is your heatsink for the SSR?
@ number40fan .. Thanks, finally figured it out with your direction .. All the best ..
@ my67nova This thing does not even get warm with an SSR40 .. no heat sink required..
@CaLviNx Not much of mine is original anymore either .. It is fun isnt it?