Delta larger Print Size
manjoel last edited by
Hallo, I have an Kossel with an Z hight of 40 cm and an radius of of 18 cm. I wanted to swith from my old ramp to an Duet3 to test little bit arround.
But I can't use this sizes in the config Tool. I there an reason there for?
@manjoel where is it preventing you from entering those values? Most likely, one of the other values you have entered is not compatible with those values.
Barracuda72 last edited by
@dc42 i wondered about that strange behavior too..got a 300mm diameter Delta...and if i wanted to fill in 150mm printable radius it wont accept it...reason is ( and thats just after i saw you post: in the tool the delta radius cant be smaller than the printable radius...so..if i want my 150mm printable radius i have first fill in at least 150mm delta radius