Cant access settings on interface
-
i installed new y endstop switch so i used the rrf configeration tool like i have many times before. but this time after installing new settings, i can get connected on web interface control but each time go to setting i get unconnected and this error
Communication ErrorAn AJAX error has been reported, so the current session has been terminated.
Please check if your printer is still on and try to connect again.
Error reason: SyntaxError: Unexpected token a in JSON at position 512
12:41:17 PMM122
=== Diagnostics ===
Used output buffers: 3 of 32 (10 max)
=== Platform ===
RepRapFirmware for Duet WiFi version 1.19 running on Duet WiFi 1.0
Board ID: 08DDM-9FAM2-LW4SD-6JKFL-3S86L-KJW3X
Static ram used: 21176
Dynamic ram used: 95928
Recycled dynamic ram: 1680
Stack ram used: 1304 current, 5880 maximum
Never used ram: 6408
Last reset 00:24:05 ago, cause: power up
Last software reset reason: User, spinning module GCodes, available RAM 7344 bytes (slot 4)
Software reset code 0x0003, HFSR 0x00000000, CFSR 0x00000000, ICSR 0x00400000, BFAR 0xe000ed38, SP 0xffffffff
Error status: 0
Free file entries: 10
SD card 0 detected, interface speed: 20.0MBytes/sec
SD card longest block write time: 0.0ms
MCU temperature: min 31.8, current 40.6, max 40.9
Supply voltage: min 11.9, current 12.1, max 12.3, under voltage events: 0, over voltage events: 0
Driver 0: stalled standstill
Driver 1: stalled standstill
Driver 2: standstill
Driver 3: standstill
Driver 4: standstill
Date/time: 2017-08-27 12:41:16
Slowest main loop (seconds): 0.009727; fastest: 0.000000
=== Move ===
MaxReps: 2, StepErrors: 0, FreeDm: 240, MinFreeDm 238, MaxWait: 1695ms, Underruns: 0, 0
Scheduled moves: 10, completed moves: 10
Bed compensation in use: none
Bed probe heights: 0.000 0.000 0.000 0.000 0.000
=== Heat ===
Bed heater = 0, chamber heater = -1
=== GCodes ===
Segments left: 0
Stack records: 1 allocated, 0 in use
Movement lock held by null
http is idle in state(s) 0
telnet is idle in state(s) 0
file is idle in state(s) 0
serial is idle in state(s) 0
aux is idle in state(s) 0
daemon is idle in state(s) 0
queue is idle in state(s) 0
autopause is idle in state(s) 0
Code queue is empty.
Network state is running
WiFi module is connected to access point
WiFi firmware version 1.19
WiFi MAC address 5c:cf:7f:ee:63:0e
WiFi Vcc 3.10, reset reason Turned on by main processor
WiFi flash size 4194304, free heap 39152
WiFi IP address 10.0.0.163
WiFi signal strength -55dBm
HTTP sessions: 1 of 8
Socket states: 2 0 0 0 0 0 0 0
Responder states: HTTP(1) HTTP(0) HTTP(0) HTTP(0) FTP(0) Telnet(0) -
reinstalled config file on sd card and works now
