Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

What to do about jerk (max instantaneous speed change M566)

General Discussion

1

1

98

Log in to reply

bot last edited by

I remember dc42 was talking about plans to change the whole motion planning system, alongside the inclusion of input shaping. Has that happened?

I find that jerk is not quite right. For curves to print well, the jerk has to be higher than it needs to be for corners to print well without ringing.

Any news on this?
*not actually a robot
1 Reply Last reply
Reply Quote 0

1 / 1