M572 doesn't report parameters?
-
Hi,
If enter M572 into the gcode console in webcontrol should I see the set parameters returned?
Thanks!
-
It works for me. I'm using the following:
Firmware Name: RepRapFirmware for Duet Ethernet
Firmware Electronics: Duet Ethernet 1.0 + DueX5
Firmware Version: 1.20RC2 (2017-12-13)
Web Interface Version: 1.20-RC3 -
In firmware 1.20, M572 with no parameters reports the pressure advance of every extruder. In earlier firmwares, M572 D0 will report the pressure advance of extruder 0, and so on.
-
Ah ok, missed the D0. Thanks for the guidance.
Should have said which machine I'm working on:
Duet v0.6, most recent compatible firmware.
-
There is a 1.20RC3 build available for the Duet 06/085.
-
Great, thanks. I'll take a look after I've printed a carrier to bolt the titan to the top of the belt carrage!
Getting challenged by these strings and with TPU I think the pressure advance/retract is only compressing or decompressing the filament in the bowden.
