Macro error

[baird1fa]

Hello everyone, I've installed a 3D touch probe on my duet run CNC machine and I'm having an issue with the macro that I'm trying to use for probing the X and Y of the workpiece.

Here is the macro that I'm using and when I call it it runs fine, but I get an error that says:

M98 P"0:/macros/Touch Probe/3D Probe corner"
Error: SD card has open file(s)

;This will probe the bottom Left corner of the work piece
;First Probe the Z height
M21                                         ;This macro uses mm moves
M98 P"/macros/Touch Probe/z probe.g"        ;Run Z probe to find surface of material
G91                                         ;Set relative moves
G0 X-25                                     ;Move 25mm away from current position
G0 Z-8                                      ;Move down 8mm, 3mm below surface of work piece
G90                                         ;Set Absolute moves
M98 P"/macros/Touch Probe/X Probe.g"        ;Run X probe macro
G91                                         ;Set Relative moves
G0 Z10                                      ;Lift probe to clear work piece
G0 X20 Y-45                                 ;Move Probe to position for Y probe
G0 z-10                                     ;Move Probe into Z position for Y probe
G90                                         ;Set Absolute moves
M98 P"/macros/Touch Probe/Y Probe.g"        ;Run Y probe macro
G91                                         ;Relative move
G0 Z10                                      ;Lift probe to clear material
G90                                         ;Absolute move
G1 X0 Y0 F500                               ;Move to new soft home

I don't see any thing about this error in my google search or a search of the duet documentation site.

There are no errors is I run the files individually, only if I run the main macro.

[baird1fa]

I found my issue, I was using a M21 where I should have had G21 to put the macro into mm.