Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Z axis clicking and going only one direction

    Scheduled Pinned Locked Moved
    Duet Hardware and wiring
    2
    3
    548
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Luca79undefined
      Luca79
      last edited by

      Hi all,

      yesterday, I turned on my printer (duetWifi board) and the Z axis stepper started clicking and apparently going only one direction (downwards). The printer was perfectly fine, the only thing I modified was a fan that I have attached (which is working fine). Anything else is working as expected. What should I look into to debug this issue?

      Thanks!

      1 Reply Last reply Reply Quote 0
      • dc42undefined
        dc42 administrators
        last edited by

        In decreasing order of probability, I suspect either bad crimp connection in the cable, a failed driver chip, or a failed motor.

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        1 Reply Last reply Reply Quote 0
        • Luca79undefined
          Luca79
          last edited by

          Bad crimp on Z2 🙂 Thanks a lot and please accept my best wishes!

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA