Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Duet LCD stuck on "Connecting"

    Scheduled Pinned Locked Moved
    General Discussion
    2
    2
    50
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • victornguyeningundefined
      victornguyening
      last edited by

      Hey everyone, I recent did a 1-for-1 replacement of my Duet 2 motherboard on my Modix Big 60 3D printer. But now my LCD is saying that it's in a state of "Connecting" which doesn't allow me to push any G Code commands. Any solutions?

      droftartsundefined 1 Reply Last reply Reply Quote 0
      • droftartsundefined
        droftarts administrators @victornguyening
        last edited by

        @victornguyening Most likely is that the firmware on the Duet 2 and PanelDue are out of sync. Send M115 in the console in DWC and post the response, and go to the 'Setup' screen on the PanelDue, and the firmware version will be reported at the top.

        Also check your config.g has M575 P1 S1 B57600 to enable support for PanelDue.

        Ian

        TronXY X5S with Duet 3 MB6HC and Roto toolboard : Cartesian bed-slinger with Duet 3 Mini 5+ WiFi and 1LC : RRP Fisher Delta v1 with Duet 2 Maestro : Polargraph with Duet 2 WiFi

        1 Reply Last reply Reply Quote 0
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA