set bed temp is not shown on DWC
-
Hello. I dont know if this shlould be or not like this: when you execute M140 S60 (just as example), on DWC I should see the bed temp set to 60 degrees or not? beecause the heated bed is heated, but in DWC the set temp area is always in 0, I can see the temp rising on the "current" field, but in active is always cero.
May be the "active " field is suposed to only show the active configured temperature, but I think it is a little confusing that setting the temperature through a gcode command is not interpreted as the "active" temp.
This is a DWC 3.5.2, on duet3 + SBC -
undefined Phaedrux moved this topic from General Discussion
-
Can you try clearing your browser cache?
-
@Phaedrux Done (manually choosing refresh is the same I guess?). Still shows 0 while heating the bed. This is not happening with the hotend temp, as soon as hotend temp is set, the value is updated on DWC
