Navigation

    Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Autoleveling needs tweaking due to small bed in big fram

    Tuning and tweaking
    2
    3
    342
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • dmkmedia
      dmkmedia last edited by

      below is a top view of my printer i have done a custom build that is 1 mtr high 5010 depth Y axis and 400 wide X axis but the heated bed hasn't arrived from the good old china post yet so i am using a 200X275 for now

      but as you can see when it has homed on the X and Y my Z probe is way off to begin homing and auto leveling

      how do I get this so it lines up with the bed

      i am now using the config tool https://configurator.reprapfirmware.org/

      so since i am used to using repeater firmware i am fairly new to this and not 100% on how to sort it

      1 Reply Last reply Reply Quote 0
      • dc42
        dc42 administrators last edited by

        Adjust your M208 X and Y parameters to reflect the actual limits of the bed. If X=0 Y=0 is the lower left corner of your diagram, then you have X min and Y min homing switches, and you will need negative X and Y parameters in your M208 S1 command because the homing switches are at negative offsets. When you have it right, G1 X0 Y0 will position the nozzle over the bottom left corner of the bed.

        1 Reply Last reply Reply Quote 0
        • dmkmedia
          dmkmedia last edited by

          Spot on thanks

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA