DWC shows two layer heights, when single height sent from S3D
-
As the title says, I'm scratching my head over an issue that I've noticed recently.
On my printer, running 1.19 firmware, when I start a print and look at the print status, I see 0.1mm/0.3mm Layer Height in the print statistics.
The print settings in Simplify 3D are for 0.3mm, with no variations.The only layer dependent setting I have configured is going from 0% part cooling fan to 50% fan when it advances to layer two.
Does anyone have any idea what drives the detection of layer height, that is then displayed on the web interface?
-
Please make your gcode file available.
Do you have Z hop during travel moves enabled?
-
Z hop is not enabled, though I have been thinking to do so, after watching it gouge a couple of the lower layers.
Here is the latest print, the back cover for a 4.3" PanelDue.
https://drive.google.com/file/d/1468K6zyNd24ylvFO1e7aVCRXsA4gUHRY/view?usp=sharing
-
Thanks. What I think is confusing it is the G1 Z0.1 command in your start GCode. If you change that to G1 Z0.3, or to G1 Z[first_layer_height] if that works in S3D, I think that will solve it.
-
I forgot that was even in there.
That is a remnant of finding z-0 and trying to get the bed levelling to behave, and somehow ended up in the start codes instead of migrating into the config.g z-probe offset settings. -
Okay, I tested this again with the S3D startup scripts no longer having the z movement preamble, after adjusting the config.g to reflect the probe height.
It is still showing 0.1mm/0.3mm layer height, and I noticed that this current print completed on layer 43 of 75.
"Layer: 43 of 75, Filament Usage: 5094.1mm of 5094.1mm (0.0mm remaining)"
Sample g-code:
https://drive.google.com/open?id=16V7LTbmVSWmawGIZLEn_tXuUV1qrGCa-Screenshot:
https://drive.google.com/open?id=1Qa93VdHxQ88LMUK7JO33bPyFtUqV-707
