Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Bed and hotend heat cuts off before reaching set temperature.

    Scheduled Pinned Locked Moved
    Tuning and tweaking
    2
    2
    431
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Brmattundefined
      Brmatt
      last edited by

      I am using a rostock max v2 with the duet Ethernet and 5 inch paneldue LCD. When i set the temperature for the bed and/or nozzle, it starts heating and the red heating lights on the board turn on, but after it heats maybe 10 degrees Celsius it stops heating and the heating lights turn off. Something with the paneldue? Heater uncoupling maybe?

      1 Reply Last reply Reply Quote 0
      • dc42undefined
        dc42 administrators
        last edited by

        Have you run the heater tuning? Check the GCode Console page of DWC or PanelDue for error messages, and see https://duet3d.dozuki.com/Wiki/Tuning_the_heater_temperature_control.

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        1 Reply Last reply Reply Quote 0
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA