Enclosure Heater and Duet
Jpmc86 last edited by
Hi all! any ideas how I can wire this guys to control it via the Duet3d web interface?
I was gifted it and I could put it to good use for a heated chamber.
I'd appreciate any help I could receive.
GeekStreetSolutions last edited by
You could possibly use a DC-AC SSR with the control terminals connected between +5V and PS_ON.
Quoting this page:
"Please note the 5v pin next to the PS_ON is an input and as it is has a diode in series with it will not output 5v. If you need 5v to power a relay of some sort you need to use the expansion connector pin 1 or the 5v pin on the vfan jumper."
dc42 administrators last edited by dc42
You could use a DC-AC SSR with the control input connected between a spare heater output on the expansion connector and +3.3V. Configure it using M141.