Navigation

    Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Problems with the Endstop Offset-Configuration

    Duet Hardware and wiring
    2
    2
    409
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • kuhnikuehnast
      kuhnikuehnast last edited by

      Hi!
      I'm trying to set up my new DuetWifi. As I come from Marlin, I am a little confused and hope, you can help me 🙂
      I use 2 endstops at the "high-end" (CoreXY): X2, Y2.
      Both endstops have a different offsets to the heated bed.

      But where do I configure this offset? In the config.g I set the axis limits. But where do I configure the "travel limits" so that the printhead is only allowed to move outside the boundary of the heating bed while homeing

      1 Reply Last reply Reply Quote 0
      • dc42
        dc42 administrators last edited by

        Configure the axis position when the endstop triggers in the M208 commands in config.g. For high end switches, adjust the M208 S0 command. For low end switches, adjust the M201 S1 command.

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        1 Reply Last reply Reply Quote 0
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA