Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Web Access Issue After Print Complete

    General Discussion
    2
    5
    591
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • driekus
      driekus last edited by

      I have had a Duet Wifi for a few weeks now without any issues. However I have run into an issue where I start a print normally. During the print I am able to view the status of the print without issues. My prints complete without issues as the last step in my print is to home x and turn off the heater. However as soon as the print is completed I cannot access the web interface. Rebooting the Duet solves the problem.

      One other oddity that I have noticed is related to my bltouch. It works perfectly in the homing step but when the printer starts printing it starts flashing. The probe does not deploy or do anything else. I do not know if this coincides with the above issue.

      Can anyone advise where to start trouble shooting?

      1 Reply Last reply Reply Quote 0
      • dc42
        dc42 administrators last edited by

        What error message does DWC give you when it disconnects? Are you running latest stable firmware (1.21)?

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        1 Reply Last reply Reply Quote 0
        • driekus
          driekus last edited by

          I am running 1.19. Should I upgrade to 1.21?

          For the error message is that the red AJAX message that pops up on the screen?

          1 Reply Last reply Reply Quote 0
          • dc42
            dc42 administrators last edited by

            Yes. DWC 1.21 and firmware 1.21 provide better error messages.

            Duet WiFi hardware designer and firmware engineer
            Please do not ask me for Duet support via PM or email, use the forum
            http://www.escher3d.com, https://miscsolutions.wordpress.com

            1 Reply Last reply Reply Quote 0
            • driekus
              driekus last edited by

              That is really wierd. I updated to 1.21 and the problem stopped happening. If I see it again I will post the error message.

              1 Reply Last reply Reply Quote 0
              • First post
                Last post
              Unless otherwise noted, all forum content is licensed under CC-BY-SA