Looking for hypercube evolution config files
Alpenprinter last edited by
I just build a hypercube evolution 300x300x300 with duet wifi
There must be a lot of users with the same hardware out there.
As I am new to duet wifi, i would be nice, if s.o. could give me the config/ firmware files as a point to start with.
thx in advance!
Phaedrux last edited by Phaedrux
I have a D-Bot CoreXY. Pretty similar to the HEVO. You can take a look at what I have if you like. I've tried to make my configs as well documented as possible.
The Gcode wiki and the documentation wiki should be permanently open in your browser too during setup.
zen last edited by
You can check my configs here:
This branch contains experimental configuration with BLtouch
I'm till testing it, a lot of problems with the clone. If you have questions just let me know.