Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    M501 behavior on Duet Ethernet

    General Discussion
    2
    3
    525
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • papilio
      papilio last edited by

      While trying to sort the issues related to probing I've noticed that M501 isn't recalling EEPROM values, it just gives me

      0_1527610635898_a1f3b942-869f-4561-a343-f78fb7c4d0c4-image.png
      (Heater is not yet connected.)

      ... not what I'm familiar with on other printers, is this normal? As far as I recall I've not previously used M501 with the Duet.

      • Michael
      1 Reply Last reply Reply Quote 0
      • dc42
        dc42 administrators last edited by

        The Duet uses the config-override.g file in place of EEPROM. So M501 runs config-override.g.

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        1 Reply Last reply Reply Quote 0
        • papilio
          papilio last edited by

          Okay, thanks David!

          • Michael
          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA