Heated bed says 'fault' and stops heating up
Vaei last edited by Vaei
I just received my DUET Wifi today. When I try to heat the bed it starts heating up, the red LED on the board turns on, the temperature increases but after ~5 degrees celcius it stops heating and says 'fault'.
I was just using my printer earlier today without any issue on the old board running Marlin.
The bed is an ultrabase 220x220x5.5 on 12V.
Suitable ferrule connectors for the heated bed were not supplied so I had to resort to wiring it directly in (and just being very very cautious until new ones arrived). Don't know if it matters but mentioning just in case.
The extruder heats up just fine.
dc42 administrators last edited by
You need to run heater tuning on both heaters. See https://duet3d.dozuki.com/Wiki/Tuning_the_heater_temperature_control.
Vaei last edited by
Thank you! I didn't see it in the getting started wiki