z probe error message
-
hello, I have an error message that I can not bring home as quickly as possible, this happens
when I z-as to home.
I am using a Lj12-a3-4 probe,
in which file should I search to find the error see screenshot!
-
@gideon said in z probe error message:
Lj12-a3-4
Looks like you're using an inductive probe but the error would indicate that it's from a servo command. Did you use a BLTouch before?
Can you post your config.g, homeall.g homez.g retractprobe.g and deployprobe.g?
-
i found the problem i usde befor a bltouch
-
Good stuff.
-
had forgotten that I tested a bltouch a few months ago but did not put anything back and then it does not work and then find where the fault lies
