Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Problems with mechanical limit switch

General Discussion

2

2

620

Log in to reply

ABDELRHMAN SAMIR ABOGABAL last edited by

i used this limit switch https://ae01.alicdn.com/kf/HTB10BMRJFXXXXX2XXXXq6xXFXXXS/6sets-lot-Endstop-font-b-Mechanical-b-font-font-b-Limit-b-font-font-b-Switches.jpg

and i want to the correct wiring with duet 0.8.5 because i connect it with the kit and the led of the indicator of this switch work correctly but the switch do not perform its job
1 Reply Last reply
Reply Quote 0
dc42 administrators last edited by

See "Makerbot mechanical endstop" at https://duet3d.com/wiki/Connecting_endstop_switches. The red wire is pin 1 and goes to +3.3V, the black wire goes to GND, and the green wire goes to STP.
1 Reply Last reply
Reply Quote 0

1 / 1