Duet Endstop Lights
rikesh942010 last edited by
I wired up my duet wifi to a Makerbot style PCB endstop. I noticed that the LED does not turn on the endstop PCB and only turns on the Duet board.
As the printer I am building has the duet on the back it is sometimes very hard to see this and was wondering if it would be possible to somehow get a LED to turn on and off depending on the endstop right next to the switch.
Any help or recommendation is appreciated
Under the heading "Duet Hardware" in the wiki there is a page about connecting endstops, and the Makerbot endstop is covered there.