Maestro connection/guide halp!
-
2.01beta I'll update and look into this. Thank you very much!
-
This can't be right.
Besides it's cloning all my macros/Gcodes all the time. Trying to revert this lol -
@fizban what file did you use?
-
these -
Ok nevermind, Now it actually updated. I had to drag and drop to make it work.
Lol I guess I'll learn this DWC some day =D
It's also a lot more responsive now on the interface! -
what the actual f.. Oo
-
@fizban Have you power cycled after the update?
-
I have, I'll re-slice it file lol. I think klipper did similar to me before I switched tbf.
-
Success!
I'm now printing again, it sounds different so I take it that the firmware altered something.I'll look into the interpolation/stealthchop thingie tomorrow.
Right now I'd better get downstairs to the missus! She feels neglected the past days
Thanks @Phaedrux you know your duet! t's much appreciated!!
-
I think the newer firmware switches to spreadcycle to maintain torque at higher speeds.
-
@Duckle Makes sense, before upgrade it was ninja silent, now it resonates a wee bit.
Gotta say I thought my 8825 was quiet, but this is wonderful. I do however miss not being able to hear if it actually runs
Anyways first test print of the cube was good.
Think I need to tune my PID, get the BLtouch sorted and fully calibrate the extruder it's off by +.07mm on the cube, and figure out some non duet stuff like why I still get vertical bands after upgrading to linear rails.
I will undoubtfully return with more questions later haha.
