Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Location for M579

fcwilt last edited by

Hi,

Is there a preferred location for a M579 command?

I cannot get my test objects (like a cube) to measure correctly in X/Y without this command.

Frederick
Hardware: A Duet equipped FT-5 with all of the 713 upgrade bits is now working well. My current project is a D-Bot CoreXY, much modified, and is now printing well. The two deltas have been retired, they didn't work as well as they should.
Reply Quote 0
1 Reply Last reply
dc42 administrators last edited by

It can go anywhere in config.g.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
Reply Quote 0
1 Reply Last reply
fcwilt last edited by @dc42

@dc42 said in Location for M579:

It can go anywhere in config.g.

Thank you.

Frederick
Hardware: A Duet equipped FT-5 with all of the 713 upgrade bits is now working well. My current project is a D-Bot CoreXY, much modified, and is now printing well. The two deltas have been retired, they didn't work as well as they should.
Reply Quote 0
1 Reply Last reply

3
Posts

216
Views

1 / 1