Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Y-axis remapping

Duet Hardware and wiring

2

3

344

Log in to reply

Army61 last edited by

I have two Y stepper motors on my old Bits From Bytes 3D Touch printer. Duet have 1 X axis, 1 Y axis and 2 Z axis male pins. Can I use both Z male pins on the Duet and remapping it for the Y axis?
1 Reply Last reply
Reply Quote 0
dc42 administrators last edited by

Yes, use the M584 command in config.g to do the remapping.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
1 Reply Last reply
Reply Quote 1
Army61 @dc42 last edited by

@dc42 Thank You so much!
1 Reply Last reply
Reply Quote 0

1 / 1