Cura Noob, help required
Tef9 last edited by
I am using my converted Tevo Little Monster to try Cura, I configured the system as best I could however there is one issue. I am using version 3.6 Ultimaker.
The printer seems to hover above the bed by about 10cm and attempts to print a large brim. The extruder goes haywire with huge moves but no extrusion and then extrudes backwards?!?
The part is a 20x20x20 test cube. So why its so large and massively offset I do not know?
Attached is the Gcode as I am very confused, I did feel it had something to do with G21 or M83. I tried slicing sever cubes (there are 6 in total) and no matter what I changed or configured it seemed to do the same thing. When I load a slic3r file its fine.
Any help would be appreciated.
;FLAVOR:RepRap ;TIME:393 ;Filament used: 1.12226m ;Layer height: 0.4 ;Generated with Cura_SteamEngine 3.6.0 T0 M190 S72 M104 S198 M109 S198 M83 G28 G21 ;G32 G29 S1 G1 Z50 F1500 G92 E0 G91 E8
It would appear you have a G1 Z50 move in your startup gcode in Cura. That would explain why it's printing in the air.
G91 E8 isn't a valid command either.