USB Power Only

  • I've been working on getting my printer up and running and managed to get five prints, but when I went to turn the printer on again I only get one blue light. I unplugged everything with the same result - one blue light nothing else. I then removed the board as the USB plug isn't easily accessible, and I see the logic lights and am able to connect to DWC. I've been following the wiring guide religiously, and I did not mess with any wires between it working from 24v and it not. Any ideas?

  • administrators

    Check that the I_5V_EN jumper is still in place, disconnect everything from the Duet except VIN power, and make sure that it isn't sitting on a conductive surface. If you still get only the blue LED lit up, please ask for your Duet to be replaced under warranty.


Looks like your connection to Duet3D was lost, please wait while we try to reconnect.