Disabling Heater, Fans, and selecting a tool
mattrmartinez last edited by
I am in need of help disabling the heating elements and fans for my duet wifi board. Currently, I can get the X, Y, Z motors the signals that they need, but to get the extruding motor to operate I am having problems. I am getting an error that is saying that no tool has been selected. The heating elements are not needed because I am doing "fresh printing" therefore the material is in a syringe and will be extruded. I will be uploading my config code this evening when I get access to my duet board.
aidar last edited by
I guess you should define tool without heater and fan : https://duet3d.dozuki.com/Wiki/Gcode#Section_M563_Define_or_remove_a_tool