Error: Cannot read file, error code 1. Cancelled printing...

[domingo]

@dc42 if I just tried several models and in simulation they end well,I've tried again in normal mode and I have another half piece Now I have a horde of turtles

[dc42]

@domingo, which firmware version are you using?

[dc42]

@domingo, is this still a problem? if so, please report which firmware version you are using.

[domingo]

@dc42 RepRapFirmware for Duet 2 WiFi/Ethernet version 2.04 running on Duet WiFi 1.02 or later

[dc42]

Thanks. There a chance (although not a large one I admit!) that changes to DMA handling in firmware 2.05RC1 may have fixed this, so please try that version.

I have this issue on my list to resolve in the 2.05 firmware release.

[domingo]

@dc42 ok, I update now to 2.05rc1 and I am telling you the progress, thank you very much for the great work and support

[dc42]

@domingo said in Error: Cannot read file, error code 1. Cancelled printing...:

@dc42 ok, I update now to 2.05rc1 and I am telling you the progress, thank you very much for the great work and support

Thanks for that information. Please let me know immediately if the problem returns. For now I will treat it as fixed.

[domingo]

@dc42 of course I would let you know, for now, after the last update, the two pieces went well

[domingo]

Hello @dc42 , upgrade from Release 2.05RC1 to Release 2.05RC2 and I have the same problems again.

This is possible?
any solution?

[domingo]

@dc42 ohh the bug has returned in Release 2.05 final

[dc42]

@domingo, is this still a problem? Are you running firmware 2.05.1 now?