@dc42 ohh the bug has returned in Release 2.05 final

Hello @dc42 , upgrade from Release 2.05RC1 to Release 2.05RC2 and I have the same problems again.

This is possible?
any solution?

@dc42 of course I would let you know, for now, after the last update, the two pieces went well

@dc42 ok, I update now to 2.05rc1 and I am telling you the progress, thank you very much for the great work and support

@dc42 RepRapFirmware for Duet 2 WiFi/Ethernet version 2.04 running on Duet WiFi 1.02 or later

@dc42 if I just tried several models and in simulation they end well,I've tried again in normal mode and I have another half piece Now I have a horde of turtles

@dc42 unfortunately, the prints always stop at the same point, replace the SD card with a newly purchased one and reinstall all the software, check the connector welds, reconnect and check all the wiring, I don't know what else to try

I have the same problem, I have already burned a lot of plastic for this problem and I don't know what else to do, change SD, install and reinstall to 2.04, the welds are fine ... what can I do?
I also read this post
https://forum.duet3d.com/topic/6788/cannot-read-file-error-code-1