SOLVED Expansion Breakout board - Configure Drive 5 and 6 with endstops
Hi, I am using the duet expansion breakout control to drive 2 separate motors (Drive 5 and Drive 6 - referring to https://duet3d.dozuki.com/Wiki/Expansion_breakout_board) . However, I wish to configure them to work with the extruder end stops (E0 and E1). How would i go about doing this?
Thank you in advance.
You can do that in firmware 2.03beta2 using the new C parameter of the M574 command.
@dc42 Thank you for the quick reply. I shall give it a go and report back.
Thank you once again