Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Print Stopped 70% of the way?

    Scheduled Pinned Locked Moved
    General Discussion
    2
    2
    265
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • tonypundefined
      tonyp
      last edited by

      Hello,

      I've had an overnight print on and it was working fine. But it's just stopped, the web UI isn't showing anything and isn't listing the Job Status. I'd say the Duet has rebooted by the looks of it?

      What's the best course of action to resume the print?

      1 Reply Last reply Reply Quote 0
      • Phaedruxundefined
        Phaedrux Moderator
        last edited by

        If something like this happens the best course of action is to run M122 to get a diagnostics report that might include some useful information. The results get cleared after a reboot, so it's best to do it before power cycling it if possible.

        Were there any error messages in the gcode console?

        To resume a print you'll have had to go through the required configuration first: https://duet3d.dozuki.com/Wiki/Setting_up_to_resume_a_print_after_a_power_failure

        Z-Bot CoreXY Build | Thingiverse Profile

        1 Reply Last reply Reply Quote 0
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA