Delta printer calibration cube sizing
RafB last edited by
I have a problem sizing my test cubes. Someone could guide me on the procedure to follow
The printer is a Tevo LM Delta
The 50cm cube gives me 49.8cm on all the axes.
Phaedrux last edited by
Have you gone through this?
Veti last edited by
double check the length of your rods. they have to spot on or your get dimensional errors.
@RafB, it's not unusual to get small scaling errors on delta printers. Either reduce the configured rod length (M665 L parameter) by the same percentage that the print is under-sized and then recalibrate, or use the M579 command in config.g to correct the X and Y scale.