Delta printer calibration cube sizing
-
Hi,
I have a problem sizing my test cubes. Someone could guide me on the procedure to follow
The printer is a Tevo LM Delta
The 50cm cube gives me 49.8cm on all the axes. -
Have you gone through this?
https://duet3d.dozuki.com/Wiki/Calibrating_a_delta_printer#Section_Correcting_for_small_X_and_Y_scaling_errors -
double check the length of your rods. they have to spot on or your get dimensional errors.
-
@RafB, it's not unusual to get small scaling errors on delta printers. Either reduce the configured rod length (M665 L parameter) by the same percentage that the print is under-sized and then recalibrate, or use the M579 command in config.g to correct the X and Y scale.
