Dear forum members,

Is there a software solution to calculate tool offset automatically for tool changers or IDEX printers?

The idea is to use a sphere in the middle of the bed, probe it with a primary tool find a center of the sphere, repeat the same with the other tool/tools, and calculate the offset of the second tool automatically to get it stored. The sphere is not perfectly at the center so coordinates have to be relative.

Basically automated tool offset setup similar to what Prusa does with XL.

The current plan is to use conditional G-Code to get 2 centers for the 1st and 2nd tools and then compare X and Y values to adjust the offset of the second tool.

Kind regards