Hello.
I purchased the LJ12A3-4-Z/BX 6V-36V Inductive Proximity Sensor and a 24V 1-Channel Relay Module Board with Optocoupler (HIGH/LOW) for swapping the mechanical switches on my Duet-controlled CNC. Is anyone using a similar setup with Duet 2 who can assist me with the wiring, please?

Greetings.

I possess a CNC machine equipped with the Duet 2 controller. The manufacturer of my CNC has positioned the controller within the x-gantry, but I am not fond of this arrangement. I desire to relocate the Duet away from the gantry and place it in a dedicated enclosure. Currently, I have one power supply for the Duet controller and one emergency switch. Since I lack proficiency in electronics, I am uncertain if there are any additional equipment requirements for effectively moving the controller.

Hello.

I need to replace the pins on two of my stepper driver connectors can anyone point me to the right direction? If it is possible I would like to get higher quality ones for the PCB and the cable end.

https://i.postimg.cc/tCHQqKkc/IMG-20230622-185443.jpg