was fixed in 3.42
Under certain conditions an extrusion-only move was executed at maximum speed instead of the requested speed
Best posts made by danharcombe
-
RE: First manual extruder move at full speed.posted in General Discussion
Latest posts made by danharcombe
-
RE: First manual extruder move at full speed.posted in General Discussion
was fixed in 3.42
Under certain conditions an extrusion-only move was executed at maximum speed instead of the requested speed -
RE: First manual extruder move at full speed.posted in General Discussion
yes faster than the selected rate for the first manual move through the paneldue or DWC.
normally i do a manual prime if I need to check things but if it goes flat out it strips the filament.
I will try a firmware update but I had downgraded as I was trying to diagnose some other issues.
-
First manual extruder move at full speed.posted in General Discussion
When I reboot my machine I have noticed that the first extruder move (manual or through paneldue) is at full speed. I have searched the forum but cant find anyting on it. It might just be this firmware as only recently noticed it.
Firmware v 3.4.1
anyone else had this?