Its now working perfectly

Thanks

@hurzhurz Yes, you are right since i dowloaded the PI image yesterday i suposed that was already with last version.

I will try again.

Thanks

@hurzhurz Im running the same, 3.4.6.

@ajmartins Well more tests, added both lines to the end of config file, and now at least i dont get any errors when restarting the board.

But when trying to make a continuous move, i still get the error:

Error: Failed to read code from macro pendant-continuous-run.g: Failed to evaluate "{exists(param.A)} && {exists(param.F)} && {exists(param.D)}": unknown value 'param.A'

Yes, i added both lines to config.g, i tried manully running and i get the other error i sent.

If i run M98 P"pendant-continuous-init.g", the system just stalls and i need to reset the board.

Should i put both lines in the end of config file?

Hi, just start to saying amazing project, and thanks for sharing ;), now one little problem... i tried to use continuous mode, but im getting some errors.

Error: Failed to read code from macro daemon.g: Failed to evaluate "global.run_daemon": unknown value 'global.run_daemon'

If i take that part, then i get another error when trying to use Continuous mode, another thing, how do i get the values to appear on the WHB04B-6?

Error: Failed to read code from macro pendant-continuous-run.g: Failed to evaluate "{exists(param.A)} && {exists(param.F)} && {exists(param.D)}": unknown value 'param.A'

Error: Failed to read code from macro pendant-continuous-loop.g: Failed to evaluate "global.pendant_continuous_ttl>0": unknown value 'global.pendant_conti'

Hi, its this APP still working? I tried yesterday and it didnt connect my DUET 3, using the URL on a browser works normally-