@dc42 In my config.g, I call a program that executes the command M552 S2.

However, since the Wi-Fi module does not turn on, I type any networking related G code into the display and receive no response. I can definitely take a picture of the board and post it tomorrow.

I know you said to remove everything, but I removed the DueX ribbon and the power connectors to the DueX and I removed the PanelDue display that I have from the main board. Powered it up and the Wi-Fi module still couldn’t boot.

Board: Duet 2 WiFi
I also have the DueX 0.11

When powered from the PSU, the WiFi module never turns on. I measured the voltage of the +3.3v using the X Stop +3.3v and the Z Stop GND.

I got a perfect 3.3v.

When I power the board with USB, the module is always able to be turned on and is functional.

The difference in voltage is that the USB voltage result is 3.306v.

When using the multi-meter, I left GND before I left the +3.3v pin while powered on from the PSU, and the Wi-Fi was then able to be turned on.

Any ideas on resolving this issue?