Once the duet WiFi board is delivered I will be adding heat sinks and fans to keep it nice and cool , just need to figure out what kind of PSU il be needing to power it all lol

@joergs5 the build area will be 500x500x1000mm (z axis is more like 800mm when finished) each NEMA 23 is rated at 2.8A so 2.5A is roughly where I want to be running them at

Ok, so how many amps would be needed? Safe to assume 200-600 watts will be enough so......say a 20amp ? Would it be enough as well as give some growing room?

Hi all this is my 1st post so forgive me if it's been covered already. I'm building my 1st printer , iv opted for a corexy design with nema23 motors , going to use the duet2 wifi with the 7" LCD , I want to use a 24v power supply but don't know which one would be best suited for my needs , as in wattage and amps .
Here is a list of components that I'd like to run
3x NEMA 23 2.8A
2x NEMA 17 high torque (not ordered yet)
1x e3d volcano hotend (maybe upgrade to duel extruder later on)
2 X cold end fans
2 X 5015 blower cooling fans
Possibly a BL touch ....not sure
6 X end stops ....may opt for optical
Duet 2 WiFi with 7" screen

I'm not running a heated bed from the supply

Is it just a case of adding up the amps and + 10% for good measure? I don't know hence why I'm posting .
Cheers .