@bogey55 @dc42 @alclonky ...okay figured it out reading a recent thread on G30...removed the deploy probe and retract probe files...problem solved

@dc42 Do you by chance know if @alclonky issue (G28 Z Error G0/G1: insufficient axes homed even if X and Y are homed / blue) was ever resolved? It sounds like I am having the same problem (on Firmware 2.01, have read FAQ#1, etc.) Thanks!

@dc42 said in It's out! Firmware 1.21 released:

Odd. In your homez.g you have the S2 parameter on the G1 Z5 command, which is the change you needed to make to homez.g. Please double check that the homez.g file in /sys on the SD card really does have that parameter, and what you posted isn't a copy on the PC that didn't make it to the printer.

The other possibility is that homing X or Y has failed. After you home X and Y, the X and Y homing buttons in DWC should be blue, and Z will still be orange because it hasn't been homed. Is that what you see?

@alclonky Did you ever resolve this? I think I have the same problem. Even after X and Y are homed when I try to home Z I get movement to the desired movement up 5, x and y move to center of bed, and then I get the error message... G28 Z
Error: G0/G1: insufficient axes homed

(Have looked at the FAQ's topic 1, etc...)